-
-
Jedi Padawan
Sorry to jump on this one so late but don't forget that if you do get a "longer" screw than you need, you can always cut it down to the size that will fit. Personally I end up with that quite a bit. I use 8-32, sometimes easier to cut, and as previously stated, if it strips out you can always drill/re-tap for a 10-32 (also had to do that a few times ).
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks