-
Parts Check
Hello,
Would appreciate checking parts before I order.
Hilt style 1 with standard style switch hole
3" Double female threaded connector
Double ended male threaded connector style 1
Screw on LED blade holder style 17 "new style"
MHS "new style" Heat Sink
MPS Pommel style 2
MPS insert style 12
MPS Clip
Activation box style 7
Activation box style 9
Luxeon Collimator Lens 8.7 deg viewing angle
Luxeon Rebel Lens Holder
Luxeon Rebel Star (Royal Blue)
LED "Corbin style" Battle blade 1" OD (36 inches)
Petit Crouton Sound Module
Premium Speaker
MHS speaker mount V2
TrustFire Protected 3.7V 900mAh 14500 Lithium Battery (2-Pack)
PCB for 7.2V Li-ion battery packs
DPDT Latching red illuminated switch
DPDT Momentary red illuminated switch
270ohm 1/4w resistor
2.1mm Power Jack
Kill plug style 2
8-32 x .3" Gold thumb screw
Thanks in advance.
Last edited by gohno; 07-08-2011 at 02:19 PM.
-
Jedi Council Member
-
-
Thank you for the suggestion. I did end up ordering 3 of the chassis disks, and I few other items but I removed them from the list since it was getting so long.
I’m not very good at Photoshop, but here is the idea.
I’m planning on putting the aux switch on the Activation box style 7 as inspired by Jay-gon’s Chrome Saber 36 (CS-36). I also decided on a different blade retaining screw as per the rendering.
Thank you very much for responding.
Untitled.jpg
-
-
No paint for now. This is going to be a co-project with my son. He is insistent that it be an Anakin Saber. This was the closest I could get without going the Graflex route. He is very excited and it should be fun to build something together.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks