Hello There!
I've been following the forum for some months now and am finally getting ready to attempt my first build. Due to my chaotic income I'm going in at the deep end whilst I can afford to!
To that end here is my design. (I think I have most of it sorted, however I do have some questions).
My Saber 2.3.jpg

PARTS LIST

MHS Ribbed Extension...x2
3" Double Female Threaded Connector...x1
MPS Pommel; style 3 v2...x1
MPS insert: style 1...x1
MPS clip...x1
Screw on LED Blade Holder; style 18...x1
Switch (Latching green dot AV)...x1
TCSS: Covertec (Silver) belt button...x1
1.5" X 12" Chrome Sink Tube...x1
Electronics Kit...x1
Petit Crouton Soundboard...x1
2AA Battery Holder...x1
TrustFire 3.7V 900mAh 14500 Battery, (2-pack)...x1
Premium Speaker...x1
Momantry switch (black)...x1
3.9ohm 5w resistor...x1
8-32x1/2" thumb screw...x1
8-32x3/8" socket head screw...x1
Extra Wire.

My major questions are: Will this sound set up work? Will these parts fit in the pommel/ribbed extension? And are there any other problems anybody can see?

I'll have to get most of the custom work done for me as my facilities are rather limited.

[And if anyone's interested the design was inspired by some already on here. Its the Saber of a Jedi Consular called Tebras Dentro, the main protaganist of the novel I'm writing, set about 170 years before TPM.]

Thanks.
Elodin