target mA......:-s

[JudgeKane]

Afternoon guys, the exchange rate has dropped for us in the UK, so my 2nd saber is winging it's way over now

but...I was having a browse about as you do and started thinking, I have ordered the LED kit again, but with a Green Seoul P4 and i opted for the 1000mA buckpuck...

Now checking the resistor list on the main site i don't see that LED listed, does it go by a different name on there?
only seeing (in green): lux lll, lux v and K2.

And if not, will the 1000mA be enough/too much?

Thanks you lovely people

Chris

[(null).exe]

Seoul P4 Green:
Part - G42182, Vf[V] (Forward Voltage) - 3.25, Φv[lm] (Luminosity (Brightness) - 70, lF[mA] (Current) - 350, λd[nm] (Wavelength) - 525, 2θ½[˚] (Viewing Angle) - 130, Type -Star

Full tech specs here: http://www.acriche.com/en/product/prd/zpowerLEDp4.asp

So yes, the 1000mA buckpuck should work fine.

[JudgeKane]

Lovely, thanks Null

[Azmaria Dei]

must have missed this a few days ago...

just an aside FYI... all P4 LEDs minus the red top out with a good heatsink between 1000mA and 1500mA normally. anything more and they get too hot, though i've heard rumors of a person or two running a couple up to 2A before. the red tops out at 800mA - i do NOT recommend going over that.