Hey guys,
I decided to take a few pics on a build I am working on and make a build thread. I don't know if any of you guys will benefit from it, but I thought some might enjoy looking at the way "I" build my sabers...
So, here are the parts for the saber, I must mention, the TCSS driver board is not going to be used. It was to expensive for the client.
So, I started with the activation box, since this will be the majority of the work on the hilt.
I measured and aligned all the holes with a caliper, and drilled everything out like so...
The box will be mounted on a 3" DF extension, So I had to drill into the threads. I also had to shave some threads off of the Male end of the Ribbed extension. A dremel cutting disk was used to do so.
That was way to stressful for me to be doing that again anytime soon...
Viola!
I will post work on the overlay tomorrow.
Bookmarks