Aluke123 on every other forum - Old grumpy moderator here
Thread Index, The Saber Building Dictionary, and The Basic Saber-Build Tutorial - Read Them!
I might have thought to try that, if I hadn't already put the LED onto the heat sink with the thermal tape, that stuff gets messed up easily if you try to move the LED after it's stuck down.
In order to see the Light,
you must sometimes risk the Dark.
TCSS MODERATOR
BLUE 8 Ready to ROCK and ROLL!
You need to take off .055" approximately to make a full 360 turn of the blade holder.
All you need to do is figure out your approximate angle of "offness", divide that by 360 and then take that answer * .055" and you'll have a good idea of how much needs removed.
or you can sand it a little bit at a time :0
AK-47s and Lightsabers, both so fun to build
Bookmarks