I'm planning on ordering very soon. Will order when the Powder Coating service is up and running so I can get my parts powder coated. So this is my final check before I order. Any help is appreciated.
PARTS
MPS Pommel style 3 v2
MPS Insert style 1
MPS Clip
5" Double female threaded connector
MHS ribbed extension v-grooved
Screw on LED blade holder style 8
8-32 x 1/2" thumb screw
LED "TCSS style" Show Blade 1" OD
SPST Momentary Guarded switch with red button
6 Piece rubber grip set 3.6"
INTERNAL
Seoul P4 - Blue
1.5ohm 5w resistor
Seoul P4 Lens Holder
MHS speaker and battery holder
Luxeon Collimator Lens 5 deg viewing angle
26 gauge wire - will get a few different colours so i dont confuse myself :P
1/8" Adhesive lined heatshrink tubing
Sound Board will be one that I've taken out of my old Darth Vader force action saber.
4x AAA Batteries NiMH
SERVICES/EXTRAS
Drill & Tap Hole - to hold the blade in
Machine Guarded style switch hole
*Extension Powder Coating
*Blade Holder Powder Coating - Hopefully the powder coating service is back very soon
What I hope my saber will look like:
And I will be using this wiring diagram:
Thanks guys, any help is appreciated. Dont wanna order my parts and find out something is missing :P
Bookmarks