MR board with Makoto V3 LED

[makototsai]

Brightness test:

2007 MR Darth Vader ANH---------------- 26~27 lux
(MR board with MR red LED strip blade)
http://www.youtube.com/watch?v=hPJLuIhl9jg


MR soundcard with makoto' s LED strip-----300~310 lux
(MR board with Makoto red V3 LED strip blade)
http://www.youtube.com/watch?v=_M4qOZdAWFE

MKTT-SSS-RED---------------------------500~510 lux
( Makoto's soundcard with red V3 LED strip blade)
http://www.youtube.com/watch?v=H6U5Yat2XzQ

I will test other color when I have free time~XD~~

[Jangotat]

Maybe sometime you could try your v3 led strip on a mrfx board, but start taking resistors off the board. I'll bet the brightness could be comparable to a v3 Makototsai saber.

[Jedi-Loreen]

Maybe sometime you could try your v3 led strip on a mrfx board, but start taking resistors off the board. I'll bet the brightness could be comparable to a v3 Makototsai saber.

Looks like he already did that. But you don't remove resistors from the board, you bridge the resistor pads (or bridge over the resistors themselves, as I've read some have done) on the blade itself.

MR soundcard with makoto' s LED strip-----300~310 lux
(MR board with Makoto red V3 LED strip blade)
http://www.youtube.com/watch?v=_M4qOZdAWFE

[Jangotat]

I've seen something like that before but didn't think he had bridged the resistors.

Makototsai or anyone with experience: in daylight is SSS bright enough to still look like a movie saver or do you need a v4?

Makototsai: what is the mcd rating on your red LED's? 3mm and 5mm