Questions about the chassis disks and threaded rods

**Waisulee** · 04-19-2011, 06:47 AM

First of I gotta say these chassis disks look great! Was so excited when I first saw them. Great job

But wanted to make sure of a couple of things. Am I to assume that the chassis disk style 2 fits well in a graflex, the treaded rods then fits in the holes, then the 3/16" OD tubes fit around the threaded rods as chassis spacers. I'm sure they fit together as I described, just want to be certain before I buy. Are there anything else I should keep in mind re these items and their assembly? Thanks

**Skottsaber** · 04-19-2011, 09:15 AM

Graflex and MHS ID's are not the same.

**Rafalema** · 04-19-2011, 11:48 AM

Yea, the disk will fit in the graflex.

But it'll rattle without mods

**Azmaria Dei** · 04-19-2011, 12:28 PM

a bit of PVC heatshrink around it will fix that though.

**IG-88** · 04-19-2011, 03:52 PM

Originally Posted by Azmaria Dei

a bit of PVC heatshrink around it will fix that though.

If you get the chassis disk style 1 it should fit inside the graflex...it's OD is 1.31" so it will still have some wiggle inside a graflex, but not as much wiggle as the style 2.