Hello everyone. For the past few months, I have been diligently researching and studying the forums. I have been working on my first sinktube saber. However, I have ran into a slight problem with the cheap Hasbro obi-wan card. My speaker seems to have come unsoldered. I can not seem to figure out which solder pads to connect the wires to. Can anyone give me any advice on soldering the wires?

On a side note, I noticed that If i wired the Hasbro sound card according to the diagram I used(7.2v, buck-puck variant) the led would stay on all the time. I had to put a latching switch on in order to turn the led off. Is there a way to wire to where the switch connected to the board turns the led on as well as the sound?