Ahsoka Inspired Saber

[Darth Midian]

I just finished my Ahsoka inspired saber. I designed this saber to be a reverse grip saber. I finally have green saber. All the other green sabers I built were for other people. All pvc construction, aluminum mini bunny ears, 1" trans white thick walled blade stock, 5 degree lens, p4 green led, resistor, 1- 18650 Li-ion Trustfire 3.7V, red dot latching guarded switch, recharge port, covertec wheel, & red anodized screw.

Top view:


Bottom view:


Recharge port:

[cannibal869]

Dude, you have taken PVC saberbuilding to a whole other level!!
Very nice work!!

*side request - could you take a close up pic of the wood inserts you use?*

-C

[Knighthammer]

Once again - outstanding PVC saber!

[jin starkiller]

awsome job

[Spidergate]

Wow!! That looks really nice. They keep getting better every time.

[dgdve]

Very very nice job.. I really like the ace style pommel on this one

[Darth Midian]

*side request - could you take a close up pic of the wood inserts you use?*

-C

Thank you everyone. I really appreciate it. Cannibal, are you referring to the wood trim I used for the grips on my Starkiller inspired saber? Here are two pics. I used wood trim that I found at Jo ann fabrics. I cut the trim to the sizes they needed to be. I then took sand paper & wrapped it around a piece of pvc & sanded the backs down so the pieces of trim would have a curve on the back that would fit flush with the pvc.

[Jedi Ranger]

Well done! That looks terrific!

[cannibal869]

Actually, DM I was asking about something different - there was a tutorial somewhere either here or on FX where you said that you use wood inserts and put them into the PVC, then dremel off the outside part 1/2 at a time. I think you use these as sort of threaded anchors for 8-32 screws?

*side note* but that wood trim thing is all sorts of awesome too!

[vctrsone]

Very clean and perfect looking replica saber! you should build her other one now she duel wields