Wiring Diagram and Hilt Check Up

[Salohcin0083]

Greetings to all,

I was hoping to get some feedback on this build idea. I am looking to have a green saber with an yellow indicator light acting as a flash on clash that is activated with either the momentary switch or the clash sensor. I would also have a green indicator light in the pommel.Attached are links to the hilt diagram I have as well as the wiring diagram i have. Let me know if anything does not look correct.
http://s1135.photobucket.com/albums/...t=Diagram3.jpg
http://s1135.photobucket.com/albums/...blank4-1-1.jpg
Parts List:
1 DPDT momentary green illuminated switch
1 SPST momentary switch with black switch(switch05)
hasbro 2010 economy board
1 yellow LED indicator
1 Green LED indicator
1 Activation box style 4
1 Hilt style 4 with guarded style switch hole
1 Ribbed grooved / Choke Combo
1 MPS Pommel style 3 v2
1 Screw on LED blade holder style 12
1 MPS Clip
1 Seoul P4 (Green)
1 Collimator Lens 5° viewing angle
4 AA battery holder
L1 uxeon III/P4 Lens Holder
1 Star thermal tape pad
1 1" Hilt safety plug (Clear)
1-3/16" ID Green O-ring
1 MPS insert style 12
1 Premium Speaker
1 MHS speaker mount V3
8-32 x .3" black thumb screw
150 ohm 1/4 watt resistor
2- 220 ohm 1/4 watt resistor
5 volt regulator

so(2/21) I decided to get an order in for everything but the blade and the driver.
I will order those hopefully next month. I will keep you posted on
a new thread in the gallery section.