how do i go about wiring a accent led to this hasbro board... would it be the led wire coming off the board as it shows in the last diagrams on page 1???
please look at the diagrams i posted in this thread - the proper wiring for accent/switch LEDs is in both of them.
Now known as Azmaria Dei
i really need "meow on clash" mya! =^_^=
duel - to fight someone 1 on 1
dual - 2 of something in line with each other
when you wire your accent Led use the original led + off the board but DO NOT use the negatives off the board (run them ALL to the tip42 base, emitter comes FROM the battery +, collector goes out TO the main Led).. run the - from the accent led back to ground. Now when your board is switched on so is your main and accent led's. Remember your meter and use proper resistors if you need them.. I hope this helps and YES go read and re read the hasbro econ thread before you start your wiring
so i have the vader sound board is it the same as what equinox posted for the obiwan???? and how do i go about wiring the clash sensor?
the vader and obi boards are the same wiring, just a slightly different layout and different dimensions.
Now known as Azmaria Dei
i really need "meow on clash" mya! =^_^=
duel - to fight someone 1 on 1
dual - 2 of something in line with each other
thank you very much what resistors do i use? i have 4.8 nimh batteries the diagram with the 2.1mm input and lux III led i dont want to get a buckpuck so i guess what im asking is what resistors would be used in place of the buck puck thank you ... if i can use resistors instead of the buckpuck i can have it built and pics posted tomrow thank you actually check that mostly built tomrow for i need a bezel yet and ran out of money to order one so i will have to wait untill then but i can post pics without the bezel or powder coating
Last edited by th hunter; 12-16-2010 at 12:16 AM.
the resistor chart is here.
http://www.thecustomsabershop.com/wi...er/wiring.aspx
just leave out the buckpuck and put in the resistor that the chart tells you to use based on the color of LuxIII you're using, which is a 1.2 ohm 3 watt.
Now known as Azmaria Dei
i really need "meow on clash" mya! =^_^=
duel - to fight someone 1 on 1
dual - 2 of something in line with each other
do i need a different regulator or just drop that regulaor in general ???? once i know this im done !!!!! on to powder coating then woot woot
no you don't need the regulator. the NiMH will put out a level that's ok with the econo boards.
Now known as Azmaria Dei
i really need "meow on clash" mya! =^_^=
duel - to fight someone 1 on 1
dual - 2 of something in line with each other
Bookmarks