Bertuzzi’s "Amphibolia" (MHS - CF V4.0)

[Bertuzzi]

Bertuzzi’s "Amphibolia" (MHS - CF V4.0)

Hi everyone,

while I’m working on the Mediator I want to show you the first proper CF-saber I made a few month ago.
So this was my first draft of the saber.



I wanted to have a simple design and it should also be no-frills so that it would be handy on stage. Unfortunately Tim from the TCSS told me he wouldn’t make custom blade holders. So I had to look for an alternative.



The parts:



Then there was something special I wanted to have. I wanted the saber to be separable in few seconds. I asked JQ for help and that’s what they made for me:





It works very well until now although the srew is a litte unpractial, a push button with a spring would be better. I hope I can replace this coupling with one with a push button. Nevertheless it’s great.

The parts to build a chassis for the board and the batteries:



I started soldering the battery pack. I encased it in heat shrink to have good isolation.



Now I drilled holes for the switches and the recharge port.



After that I started abrading a 32mm PVC tube down to 1,25“ so it should fit into the MHS extension.





Now I drilled holes in the chassis for switches, RP and the Covertec screw.





The I cut the PVC tube to the right lenght and tested the hub of the switches.







Next I cut a board to mount the CF and the batteries.







It should look like this:



Unfortunately I the heat shrink was to big for the ribbed extension, so I had to remove it and just fix the batteries with tape.



Now I glued the switches into the chassis





Testing.



Everything to do now was the final assembly.





That’s it. A very simple but handy saber. Until now I did some modifications. I will report on that later. Good photos will follow, too.

Comments requested