MHS speaker mount V2 "lip"??

**cannibal869** · 10-27-2010, 01:18 PM

Just a question about the MHS speaker holders...

the one I'm talking about is this one:
http://www.thecustomsabershop.com/MH...t-V2-P314.aspx

I've gotten a few of these with a small "lip" of plastic around the edge. I was wondering if this is intentional or not? Cause the TCSS speakers don't seem to sit into the "cup" very well without some modification with a dremel. Anyone else notice this?

I've been able to dremel the lip down so that I can then push in the speaker and "lock" it into the mount but it requires an extra step...

-C

**Skottsaber** · 10-28-2010, 08:34 AM

Can't say I have. I bought one of those in January though.

**Crystal Chambers** · 10-28-2010, 09:05 AM

maybe the speaker snaps in...I seem to recall they've been changed.

**Ronan** · 10-28-2010, 06:21 PM

Speakers snaps in... How would it hold in place otherwise?

**Lord Maul** · 10-28-2010, 06:52 PM

On the ones I have there's no lip, but I haven't bought them in a while. I just glue them in.

**cannibal869** · 10-28-2010, 11:26 PM

OK I figured it must be intentional... any easy way other than brute force to get these in? I.e. anyone find a good tool to help push these in? Cause I think I ended up destroying at least 1 speaker trying to force one in without dremeling the lip down a bit...

**Strydur** · 10-29-2010, 07:33 AM

I just lay the speaker down on its face and then push the speaker mount onto it.

**cannibal869** · 10-29-2010, 08:33 AM

insert facepalm here...

duh...thanks Tim!

**equinox13** · 10-29-2010, 09:05 AM

Originally Posted by Strydur

I just lay the speaker down on its face and then push the speaker mount onto it.

a very simple application of a flat surface as a tool... we should start listing these in our tool inventories... O.o

and i would have used a rock...