I hope this is where it should be posted so here goes...
i was doing some final testing for fitment into my obiwan hilt before i finalise my solder points (messy) and apply the hot glue. I thought i better test the led and so on and wired it up. As soon as i removed my kill plug the led lit up even though it was very dim.
I thought here we go what did i do now and went over the board to see if any of my exposed wiring was shorting anywhere. I couldn't find anything wrong so i went ahead and removed the plug (same result) and i activated the switch.
The led lit up like xmas but was still dimly lit upon deactivation. I did the jiggle test to see if anything was loose and the black thing you see pictured fell off.
The board still works fine for sound, swing and clash, but the led doesn't quite switch off.
So i am requesting the assistance of Masters on these forums to tell me how bad i fudged this up and what i can do to to replace this piece. So any help will be greatly appreciated at this point and i would want to avoid the DPDT switch option at this point.
Once again any help will be greatly appreciated.
Thanks in advance.
Bookmarks