So as most of you know, I am tackling a project which requires making a custom saber out of a ventress board. The board (after desoldering the switch) has 5 pins/pads and I am not quite sure how to make use of them when attaching my own switch. The pins on the board have 5 pads as follows:
ON ~ On/Off ~ On/Off ~ On/Off ~ OFF
You can find an image of the switch pad marking here:
*** Update ***
So as mentioned earlier, there are 5 pads under the switch once you remove it. When looking at the board with the mollex connector on the left, and the pads facing you... you need to wire pins 2 and 3
ON ~ On/Off ~ On/Off ~ On/Off ~ OFF
Bookmarks