Was working on a build using the hasbro dvd board. Using the wiring diagram that uses the pnp transistor etc. All was going fine. Fired it up, LED went on, then after several seconds, went off while board was still powered up. No smoke, nothing. Just stopped lighting up.
I realized after I had thought I was using a green Lux 3, but it was actually a rebel star (too many LEDs floating around the work area!). I had a 2.2 ohm 5 watt resistor in place.
I've attached other LEDs and they all are lighting up. But my green rebel is still no dice. So, did I kill her?
Bookmarks