After finishing my first MHS-style saber, I really wanted to try my hand at PVC. I had a lot of inspiration from different sabersmiths here in the forums, such as Jay-Gon, Darth Midian and HAVOK. This saber took me about a week from start to finish. I fully intend to put in a Red Rebel Star and the 2010 Hasbro Sound Board. The electronics have not been ordered, as you can see I haven't even drilled the switch hole, yet. The switch will go on the black overlay just below the blade screw.

Materials Used:
1", 1.25", 1.5" PVC plumbing pipe (the 40-Graded type)
1" PVC plumbing end cap
3x Rounded 8-32 Screws
1x Wood Screw with 8-32 inner threading (thanks, Jay-Gon)

Tools Used:
Black and Decker RTX 3-Speed Rotary Tool
Hacksaw
Black and Decker 14.4V Cordless Drill
Valspar Plastic Paints in Black, Red and Clear Coat
220-Grit Sandpaper

No other tools (drill press, table saw, etc) were used in the production of this hilt.