Fixed that for you.There is no "3 prong harness" on this board though.....The little pcb above the board is the clash/motion sensors. It looks like the motion sensors are wired parallel to each other using the brown and red wires. The clash sensor is wired using the orange and yellow. Polarity really doesn't matter on these, as they are simply switches that temporarily close a circuit.
Last edited by Jedi-Loreen; 08-03-2010 at 07:14 PM.
In order to see the Light,
you must sometimes risk the Dark.
TCSS MODERATOR
BLUE 8 Ready to ROCK and ROLL!
Bookmarks