i need help on how to put the button for the covertech clip on my hilt
i bought the machined and i also have the regular button that came with the clip
any help would be good
i need help on how to put the button for the covertech clip on my hilt
i bought the machined and i also have the regular button that came with the clip
any help would be good
bolt or rivet it on.
Tim
The Custom Saber Shop
Hopefully you know that you'll need to drill a matching hole in your hilt in order to mount it.[]
http://www.members.shaw.ca/Dahak/
I purchased an aluminum covertec button from Tim. The shops says it is curved for a 1.5 inch pipe. I attached it to a 1.375 inch pipe and it looks just fine.
Here is how it looks:
Forgive the poor picture quality, I used a camera phone. Anyway, the button (wheel? knob?) is attached using a 6-32 x 1/2 inch button-head cap screw. I drilled and tapped a 6-32 thread hole in the hilt. For added security the screw also goes into a small 6-32 nut inside the hilt. I think an 8-32 screw would work too, but I have an over abundance of 6-32 machine screws.
Question, is the piece I purchased anodized? how about the blade holders?
Lightsaber Warning Label: "CAUTION: Do NOT attempt to sharpen blade."
Those buttons might have been..the other stuff I sell is not.
Tim
The Custom Saber Shop
Bookmarks