ive been reading the forums, and ive noticed people sanding their blades. does this make them brighter? i couldn't find a thread about blade sanding.whats the best grit to use?
ive been reading the forums, and ive noticed people sanding their blades. does this make them brighter? i couldn't find a thread about blade sanding.whats the best grit to use?
I used 400 as I read about some one else using it...and it just makes you blades outer edge a little more defused looking.. your roll of cellophane or what ever you use isnt so visible, it blends into it.
the blade in my pics below is sanded. It gave it a pearl kind of effect.
Last edited by vctrsone; 07-09-2010 at 04:33 AM.
}---------------{
]-----------------"Fullmerge Benzin"----------------------------------------:Beware of the dark side:--------------------------------------- "Fierfek"--------------------------------[
It makes the blade look "fuller", sort of like the Ultraedge, though not as dramatic. It also doesn't make your blade look like an Easter egg like the ultraedge seems to do.
If you're new, please take the time we all consider just as precious as you and READ!
GET LATHED!
Official BMF and LORD OF THE STRINGS
Sanding the outside of a blade can bring the light to the outer edges of the blade, so that it has less of a "light inside a tube" look.
If you sand around the circumference, it can also give you a slight "core" effect, like the blade film from the Store does.
If you duel against other polycarbonate blades it will make smooth spots on it, so you will need to resand your blade periodically.
In order to see the Light,
you must sometimes risk the Dark.
TCSS MODERATOR
BLUE 8 Ready to ROCK and ROLL!
I just built my first 30" blade..now I need some one to duel!! ive been running around the streets with my light saber but so far no ones taken me up on the challenge!
}---------------{
]-----------------"Fullmerge Benzin"----------------------------------------:Beware of the dark side:--------------------------------------- "Fierfek"--------------------------------[
Okay I'll warn you, I had my hilt attached to my hip at Ace Hardware today. Man did I get some strange looks .
As for the topic at hand. I have found that using 120 grit, 220, then 400 grit SP makes the process of sanding easier if done by hand. I think it looks pretty good. My blades have diffuser in them, for now. I do want to see how a sanded blade (that I have done) looks with out diffuser. I'm guessing not as good.
Though I have not tried it I think that someone could use the same sand paper employing the same method in sanding the chrome off of sink tube.
The cool thing about sanding the blade is it removes the "Light in tube" look. That's the best way I can explain it.
I use 400 grit sandpaper going from top to bottom. I takes maybe 10 minutes but the results are awesome!
Got a Question? There's a thread for that...
~Do what you can, with what you have, where you are.~Teddy Roosevelt
SollusVir everywhere else... FXsabers, Youtube, etc...
Hey, you know what else it does...it gets rid of that annoying light in a tube effect:P
If you're new, please take the time we all consider just as precious as you and READ!
GET LATHED!
Official BMF and LORD OF THE STRINGS
Bookmarks