-
-
wow, this is totally incredible.. for me anyways. Great stuff. Gives me hope for and ideas for my saber. Is there some special type of pvc you used? I haven't found any that slides in snug as an overlay. Either it is too tight (won't fit in) or too loose.
-
Sith Adept
Duncan, I'm just using 1" & 1 1/4" pvc. With this saber I'm using 1" male & female electrical pvc connectors for the pommel. The 1 1/4" pvc dosen't fit snug over the 1" pvc but I don't worry about that because I screw it down.
Last edited by Darth Midian; 06-13-2010 at 02:04 PM.
-
ok, I thought you found something that had a good fit. Screwing it down locks it in place, but will it leave a noticable gap on one side?
edit..
Ok took a closer look at one of your pics with the sleeves put on. Yes there is a gap. I quick thought that popped into my head would be to put some plastic/vinyl lining of some sort with texture under the area with the cuttout. Big enough to fill in the gap (tighten up the fit) and give the illussion of another level of detail. Just a thought.
Last edited by duncan29793; 06-13-2010 at 02:31 PM.
-
-
Youngling
-
-
-
wow, that is simply amazing. GREAT JOB.
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks