Ok I searched for about 3 hours last night and just got more confused as I did so I'll just post my question here. I am upgrading from a lux 3 (blue) to a less seen lux 3 red orange. My curent set up is using a MR FX board running off of 4.5v the specs for the blue is 3.9FV @1a but the spec for the red/orange is 2.95fv@1.4a so what I'm trying to find out is can I run the red/orange off the fx board? Just a simple swap? Can the led Handel the higher voltage? Some of the post I saw said they could some said no otheres didn't specify.
Any advise from some of the more seasoned vets? On a side not I was thinking of running 2 700ma buckpucks in between the board and the led to get the 1400ma I need if this won't work either pls some one stop me now!
Thx
Bookmarks