Luke FX soundboard and lux3 wiring?

[xwingband]

Well, EL does take 9V. That would be good for a Lux V. That's what I plan on when/if I use my EL board.

It is usable just not for driving the Luxeon directly. You'd have to setup a relay or a DPDT switch that would direct drive the sucker via a resistor.

[erictank]

Well, EL does take 9V. That would be good for a Lux V. That's what I plan on when/if I use my EL board.

It is usable just not for driving the Luxeon directly. You'd have to setup a relay or a DPDT switch that would direct drive the sucker via a resistor.

Maybe I'll save that for a white Luxeon 5 saber, then, and wait on Erv's buttered-toast board for my 3W Jedi saber. Not like I'll be building either of them tomorrow anyways. Thanks for your input.

[james3]

Looks like xwing took good care of ya.

I have an AOTC Anakin that is just sitting here and I keep thinking should I convert it or leave it be. 5w is the way to go on it though for sure.

[Ryma Mara]

With the el boards there just sound right?

[xwingband]

With the el boards there just sound right?

You'd only be able to use them that way. That's if you wanted Luxeon at least.

[vortextwist]

then the el board dosent have any blade effects correct

[jjshumpert]

not that you would be able to use, you would have to do a direct drive to the led and sound with both run thru the switch, its a pain to convert an mr el saber, i did with a aotc ani and it wasnt pretty