Updated build thread.
Updated build thread.
You might want to put your buttons in the 1.5, intead of cutting a window and putting them in the 1.25. Just safety wise.
Does that 1.5" MHS to ST adapter fit over the 1.25" ST snugly?
having a exposed edge of recently cut, then metal where your thumb will often be.
Got a question? Start Here. Have you tried the Thread Index yet? Most questions can be answered there.
Ah, I see what you are talking about. That wont be an issue since I will be sanding down all the edges nice and smooth.
I sanded down the ends that I cut using a flap wheel and they are perfectly safe.
OK, thanks. I was just wondering if my board had maybe been repaired or modified.
Last edited by Rathan; 06-01-2010 at 10:45 AM.
Any more progress on this?
So many things working against me.
1. I don't have a garage/basement/workarea so I have to work out on my uncovered patio...which means getting anything done is weather dependent. LOTS of rain in Chicago over the last 2 weeks.
2. My lack of experience with the dremel ... one slip and I have to redo the main chrome tube.
3. Painting the plastic slip-rings on the inside tube BEFORE sliding the outside tube on ... just don't work. I am going to have to sand them down and paint them later after most of the assembly and a lot of making tape.
4. Parents are coming in from out of state for a week long visit on Monday and staying in my 2nd bedroom. So, lots of crazy cleaning and moving of things in the "storage room".
Rain is supposed to be letting up tomorrow so hopefully I will get some work done and pictures posted.
Bookmarks