Ok, getting ready to buy the parts for my first saber, want to know if I'm missing anything. I have spent the last 2 weeks going through the forums looking up info, so hopefully I have figured out what I need...
HILT...
pommel #3 v.2
pomel insert #6
main body #2 guarded switch
ribbed extension
blade holder #16 (pre-drilled & tapped for retention screw)
ELECTRONICS...
SPST guarded switch (not illuminated)
LED Rebel or P4 green
LuxIII lens holder
5 degree lens
4AAA battery pack
QD wire for LED
heatshrink tubing
buckpuck (4 wire) either 700Ma or 1000Ma depending on LED choice)
*note: I will be adding a MR soundboard sometime in the future, but I can rewire later
BLADE...
Ultrasabers UltraEdge (will sand to fit if necessary)
Once I get the saber built and working, I'll worry about adding extras like a D-ring. Do I have all the parts I need here? Also, any advantage between Rebel and P4 LED's on power usage? Volts seem to be close, but the P4 is listed at 1000Ma verses the Rebel at 700Ma. All of the comparisons I have seen on brightness seem to place them about equal (at least with green).
Bookmarks