Hello all. So after months of lurking and getting to know a few of you, I am ready to solder up my first MHS! However, I've run into one hiccough. I've gone through the MHS LED kit tutorial (Buckpuck variant)
(http://forums.thecustomsabershop.com...ead.php?t=8536) and Recharge port hookup (the part entitled "Kill switch") (http://forums.thecustomsabershop.com...ead.php?t=2235)
and am trying to combine the two circuitries. The Buckpuck tutorial shows the black/neg from that battery going straight to the puck, and the black/neg on the Kill Switch goes to the bottom terminal. The Buckpuck tutorial shows the red/pos go from puck to switch to the battery's red/pos, while the Kill Switch shows red/pos from both the battery and board going
to the right terminal and the board's neg going to the left.

At first I thought the plug will simply go where the switch was in the Buckpuck tutorial, but this would of course lead to a black/neg not connecting to the Kill Switch. So I knew this was wrong. My best guess is as follows...

Please let me know if I am correct, or if I'm totally off! (Note: I have no board yet, that will be phase 2.)