I probably should have done this before ordering. But i used the http://forums.thecustomsabershop.com...ead.php?t=6430 basic MHS noob thread. and have chosen these configurations.
* 1 of: 1/8" Adhesive lined heatshrink tubing
* 1 of: 8-32 x 1/2" thumb screw
* 1 of: Screw on LED blade holder style 18
* 1 of: Hilt style 3 with guarded style switch hole
* 1 of: MPS Insert style 6
* 1 of: 2 Wire quick connector
* 1 of: MPS Pommel style 7
* 1 of: Build Your Own Seoul P4 Electronics Kit
* 1 of: LED "Corbin style" Show blade 1" OD (36 inches)
* 1 of: MHS ribbed extension
* 1 of: Powder Coating (Super Wet Black, RIB3)
Im a wee worried that the blade holder is either 1" or 3/4" which means the blade wont fit.
Tim would have told me if they werent appropriate wouldnt he?
All good?
Bookmarks