HyperDyne Labs SaberSD wirering

[mongo]

Here's a diagram of my set up, the 7.2v pack has been replaced with a 14.4v- a 5Volt regulator -LEDEngin 10w replaced with an SSC p7

[RattleHornet]

Thank you, mongo !
It seems to be very nice. I want to try it.

Adjustable LED driver + Add-on board + Shipping cost to Japan = $86.5

hmmm...I must consult with finance

[mongo]

My theory is you only live once,1days work out of the month,for a kick a$$ toy i can afford that .

[RattleHornet]

I did it!
Following a Japanese saversmith's instruction, I did wire my circuit like this diagram.


And edit configuration file(mode.txt) to use vibration motor like this.
vibenabled = 1;
vibwhilehum = 1;
vibswinginten = 64;
vibclashinten = 64;
vibhuminten = 64;
viboninten = 64;

LED and sounds are perfectly sync when ignition and retract.

[mongo]

That's one way to hook it up,but be careful with that LED on the motor circuit.I did that about 3 months ago,and blew my motor circuit.Plu

[RattleHornet]

Thanks mongo, I did that just you attentoned. my motor circuit was blew.
Last night, I tried transistor instead of relay. Then, after I did something, motor circuit was overheated and gone.

So, your way is only last way to use this difficult board.