Search:

I have already done this type of install with BBW tri Cree, this is the first time doing RB RB W. That is the only difference.

Thanks for the info. I am curious in regards to the NB since there is only one LED driver pad driving 2 of the 3 tri cree’s, why would I need 2 resistors on one wire? When I wire up the prizm it...

This is my 10th build, 4th Nano biscotti and this the first time this has happened.

I have a tri-Cree RB,RB,W, Nano biscotti, and 18650 battery

Wiring is per usual: positive battery to charge...

Fits like a glove

The sides from the inside have a 1 inch opening the custom saber shop 1 inch led/heatsink plop right in from the inside of the saber. One side was a little too tight so I used a...

I just finished machining the blade holder. Rather than over complicate things, I bought the custom saber shop 1.5" sink tube LED\Blade holder, then I machined it down to fit the hilt. I took a...

are you saying no resistor on all? I though I needed a 1.2 ohm on each red and a 1 ohm on the white. I would like white to do the lock up as well.

I think they are 180, but they are only available at the Disney parks. I got mine for 144 cause my brother gets a 20% discount.

As for demand, not to sure about that. I see them being sold on...

I am planning on doing a saber with crossguard\trident setup. I am using the Prizm 5.1 board a 18650 and (1) tri cree LED Red Red White and (2) xpE2 Red.

Since the prizm has 3 channels I am...

Glad I asked. OK, so if we use the 3.7 what resistors am I going to need?


I am thinking a 1.2 ohm resistor on all red and 1 ohm on the white.

Thoughts?

Hey guys, I am a newbie here and am looking for a little help.

I am setting up a saber with a Prizm 5.1 and a Lion 7.4v battery pack. I am a little lost with the resistors I will need.

I have 1...

I am in the process of converting mine to tri crees and a prizm 5.1. I already stripped the hilt down, I have the 3D printed chassis from Justin. I think this week I will be making the LED\ Blade...