Yes, I am using NiMh not alkaline AAA's. Had already successfully gotten it to work. Just edited the original post yesterday in case anyone else was wondering if it would work. Battery life is...
Type: Posts; User: Bossman
Yes, I am using NiMh not alkaline AAA's. Had already successfully gotten it to work. Just edited the original post yesterday in case anyone else was wondering if it would work. Battery life is...
Hey all, I posted a few weeks ago about adding a Bladebuilders board to an Ultrasabers dark Initiate stunt saber. I couldn't get that to work due to some issues with the transistor, so I decided to...
Update:
I bought another new Bladebuilder saber and only clipped the LED prongs, so that there was no soldering issues for testing. I used a set of test leads to hook up to the existing wires, a...
Good ideas, thanks for all of the help! Hopefully I'll be able to figure it out.
Cheers,
-Bossman
Im going to go through the entire board again and check for a bridge, but im wondering if i need a different resistor for it given the change from stand alone led to now going through the board...
The neg wire from the LED is attached to the LED - on the board, in through the top. The one leg from the tip42 is bent around and soldered to the same location.
I'm using the quad AAA battery holder that came with the saber from Ultrasabers and running rechargable NiMH batteries. Just took the bulb assembly apart and saw that the LED is a Luxdrive A007 Indus...
1326313262Ok, so I just wired it all up. Have sound, motion and clash...but no led. Double checked the diagram vs what I have. I'm using the resistor that was already on the negative lead from US,...
Hey thanks for the diagram! Really helped me figure most of this out.
I do have a couple of questions though. I'm modding two Ultrasabers stunt sabers with these 2015 Hasbro boards. The sabers both...