thx for the advice, was already my idea to isolate it, but i also tried to swing the hilt keeping the mosfet away and isolated with some duct tape just in case....still the same issue :|
Type: Posts; User: Anghelos
thx for the advice, was already my idea to isolate it, but i also tried to swing the hilt keeping the mosfet away and isolated with some duct tape just in case....still the same issue :|
I already use a plastic pipe to avoid the exposed wiring to touch the aluminium... in the dropbox there are pics about :)
Hello!
After lots of weeks of works i finally managed to prepare my hilt with inside the hasbro board, problem is...that doesn't work properly.
While outside the hilt or just inside the hasbro...
Hello again...
While i was making my test according with mu old schema, i found out that I couldn t switch to different color....every time my blade was always white.
This happens because the...
https://www.dropbox.com/s/3t731unoina6nbu/CircuitHasbro%20-%20RGB.png?dl=0
So, as you can see my diagram is slightly different, mostly because i use a different recharge port (a micro usb) and a...
Badly, my configuration is a bit different:
I ordered a rotary switch 8 position 1 way to cycle the colors through it, so i can decide what color i want to show during my usage.
now, in order to...
Can u post a short video about?
So when the bladr is hit or lit u have the multicolor blade?
And u have this attaching the pnp base to spk neg?
Hello,
As most of u know, when hitting with a bladebuilder hasbro 2015 the effect on the blade is a flickering: basically the light turn off and on rapidly to make the effect. I want to avoid...
Hello again,
I was making some tries on my blade and led, and found out that if I attach a Trimmer / potentiometer to manage the light, it give a nice opening and closing effect, very similar to...
the bypass speaker solution seems the best for the moment :D
oh...I see...
The usb charger should have the protection (or at least i hope so ^^') but the battery does anyway.
If u say that it uses so low current, then i think i will apply this idea....
...
that's a very good idea actually!
But I wanted to use the less energy possible, so, I want to bypass completely all the soundboard....I fear that with this idea i might still have the soundboard...
https://www.dropbox.com/s/n262gbv4xvk7ff5/CircuitHasbro.png?dl=0 let's try like this ;)
Hello everybody :)
I'm trying to make my own lightsaber with sound using the Hasbro Luke Skywalker bladebuilders 2015 LB.
I wanted also to add a rechargable battery with a micro-usb so I don't have...