Thanks everyone!!!
The emitter and pommel as with the rest were acid etched. Then I hit the whole saber with a Prismatic Powders Tinted Clear II which gave the etched surface a darker grey...
Type: Posts; User: RMDphoto
Thanks everyone!!!
The emitter and pommel as with the rest were acid etched. Then I hit the whole saber with a Prismatic Powders Tinted Clear II which gave the etched surface a darker grey...
Yeah, so I don't have a name for it. But here is my very first build. All TCCS MHS parts, featuring a full MHS chassis with an NBv4, recharging, Red-Red-Deep Red tri-cree(set for FOC), and bass...
But if I remove the remove the chassis disk then the chassis will slide around in the hilt. I got exactly what was listed in their video so it would lock into place between the hilt and pommel.
Hey all, I put together all my parts that I ordered and I am getting a gap between the Hilt and the Pommel. I ordered the chassis parts based on this video....
Thank you much, thats exactly what I am wanting to do with the LED's
Well, I found a resistance calculator and I added two 1.5Ohm 5w resistors to the wishlist along with a power extender to do flash on clash.
Would really appreciate someone looking everything over...
Hey all, so this will be my first DIY build and am a bit intimidated.
This is what I am going toward, a custom etched take on a dark side Satele Shan saber. (will end up doing two down the...