Search:

I'm going... with my wife and my new saber.

It's the 1000 mA. That's the one that is sold on the US site and the one that is installed on the grab bag that I bought for my wife.

After doing some research, I think I might just use a buckpuck rather than a resistor. Mostly because I can't get a good answer on what the forward voltage and mA current is. Thank you for your...

Okay, color me a noob...

I am looking up the TIP42 PNP Transistors. I have found THIS ONE, but I'm not sure if it is what I need. If it is, let me know, if not, could you suggest one?

Second,...

After building my first PVC saber based on JayGon's designs, I am looking to build a saber with some sound. This will again be PVC, but I am also going to use some Epoxy putty to give it a unique...

Personally, I name them after the inspiration behind them. My Mara Jade saber will be called the Jade Hand. My Aayla Secura TCW saber will be called the Bare Blue (don't judge me). My TCW Anakin...

There's already a site for that.

http://astromech.net/

It's the astromech builders association. Though, they build more than just Astromechs.

The slatted part is going to be the cut off part from the outer pipe that is cut into slats, painted, and glued back down. It will be slightly smaller (by the amount of the cut). As you can see...

Parts List
Electronics Parts
-Build Your Own Seoul P4 Electronics Kit
--4AAA battery holder
--Seoul P4 (White)
--Collimator Lens 5’ viewing angle
--3.3ohm 5w resistor
--Push on/push off switch...

Inspired by Jay-gon's PVC Hilts, I am going to start designing and building a series of hilts that are seen through the Expanded Universe. At first, I plan to make only lit sabers, but soon I plan...