Thanks. I wanted to try the corbin blade so I will try the thin walled version of that first. If that doesn't work I may think of trying an extension, but I am hoping that isn't needed. Good tip on...
Type: Posts; User: TankAviator
Thanks. I wanted to try the corbin blade so I will try the thin walled version of that first. If that doesn't work I may think of trying an extension, but I am hoping that isn't needed. Good tip on...
Hello all,
I did some searching around about trying to balance a hilt with a blade in it and I didn't get very far. I have all of my electronics as far back (towards the pommel) as I can go and...
I have the CF 6.5 with the stock fonts. I haven't spent too much time trying different sound fonts out yet. That is one thing I would like to take some time to do.
Thanks. I have the CF + color extender combo, so can address each of the colored dies individually. I am currently running 278ma on the blue die and 1.5a on the green die. I am able to overdrive the...
Thanks. I did do a few practice shrouds on some sink tube to get in some practice and work on proportions. I have 2 rgb LEDs coming in to connect to my aux LED ports. I figure that will give me a...
This is an MHS build with a CF main board + color extender. 7.4V 2600mAh pack powers the RGBW LEDEngin. I was kind of thinking the blade would be a bit brighter :).
89748975
So I figured it out. It was actually the intersection of 2 different problems. First, it looks like the pinout of the type 1 RICE port is reversed from the type 2, and the type 2 is what is shown in...
The primary switch was in the off position (no sound or main LEDs) but power was flowing to the controller (neither the kill key nor a recharge cable was plugged in and illuminated primary light was...
Hello all,
I have my first saber built with a CF 6.5 and color extender. Everything except the RICE port is working fine. I am using the type 1 (metal body) connector along with a recharge port...