Thanks for your help. I was able to get the board replaced, but I could not keep the power extender wiring the same from the NBv2 to the NBv4 version. I did remove the power extender, and wired it up...
Type: Posts; User: TobyTheTerrible
Thanks for your help. I was able to get the board replaced, but I could not keep the power extender wiring the same from the NBv2 to the NBv4 version. I did remove the power extender, and wired it up...
Avidgrant, is there any point to keeping the power extender with the NB v4? Doesn't the pex just supply the needed drive to the die that the v2 board couldn't handle? Thanks for your help.
Thanks for the quick answer!
Hey everyone,
I have a quick question hopefully. I had a working RRW Tri Reb with a NB v2, w/ single 18650, until the board died on me a few weeks ago. I've purchased a NB v4 as a replacement and...
FJK, I can confirm this worked. I appreciate your help so much!
Okay thanks! My setup is similar to the one pictured in the NB v2 manual for tri rebel and the two main red LEDs in this case are powered from the battery and return to the NB in the High Power LED...
switch LED+ is connected to the battery & dynaohm.
Martyn & Jay-gon, I appreciate your help.
I would like the switch to illuminate only when the main blade LED is turned on. I currently have the switch's LED ground and switching ground both...
Good morning Forums.TCSS, I hope you're doing well!
I'm wiring up a red ring momentary switch to be used with a Nano Biscotte v2. I want the switch light to be off when the blade is off. And...
Ah okay, I knew they needed 5v but since I'm giving 7.4v total, does the voltage cut in half since its in parallel not counting for the draw of the AV light?
Thanks for the quick reply and the...
Hey Everyone! This is my first saber build and everything works, but I'm looking for a few pointers. Note: all back wires to go black and red to red. I don't know of an easy way to show overlapping...