Search:

The Resonat Victoria was a my entry in lue of parts not arriving in time to finish the more exciting saber I had been planning (don't get me wrong -I love Resonat Victoria and consider it my...

This is correct. I have only drilled through threads once so far myself (put a guarded switch in that part of the body) and I found it worked well to have the parts put together like I wanted and...

NB3 can have up to 2 fonts at a time.

Chasm is right about this. In case it's helpful I just re-measured the mhs v2 parts I recently got for my own first attempt at a v2 build and the ID is indeed right at the 1 inch / 2.5mm mark as...

Yeah I was mainly concerned with whether getting enough for the appearance like you showed in that video took thousandths, hundredths or tenths (was guessing about .01"-.02" but hard to gauge that...

I would love to be able to enter the contest (I'm sure I wouldn't come close to winning with all the amazing sabers I've seen in previous contests but I do think it'd be fun all the same). My problem...

Thanks for the tutorials you've been putting out (I've subscribed to your youtube since finding it) they're very informative and your amazing work has been inspiring me to consider doing a crystal...

I'm actually going for an indigo blade. I've achieved it with a pot. To be honest it kind of surprised me that I needed that much resistance too.

Thanks for taking the time to look at yet another of the myriad resistor question threads. I am hoping a veteran smith/etc can help verify what wattage of resistor I need on one of my lines.

My...

I'm actually just finishing up an indigo bladed saber myself. For my build (running off of a 3.7v 18650 Li-Ion from the shop) I used a R/rB/W tri-Cree. I run the rB with a 0.5ohm resistor and ended...

I can file the nuts down but I do not want to make them overly difficult to remove down the road (So I'm not as excited about using glue) since the end of the chassis where they protrude is also the...

If I go the sanding route I'm leaning more toward using a hand file or sanding drum on my rotary tool so I only am rounding off the 1 offending corner of the nuts (I'm worried rounding them off...

Great to know! Thank you so much for the (very) quick reply. :)

Greetings everyone. I have been lurking on the boards for some time learning and planning out a build before finally taking the plunge and ordering parts back in the fall. Finally, in the past month...

Greetings all. I've been lurking for the past several months and reading everything I can to learn more about this hobby. I finally ordered my parts in October and got them last month and have been...