It worked fine for me, using the drivers for windows 7 that are linked from the store page for the R.I.C.E. cable. I at first thought the software was to blame but then i switched the TXN and RXN...
Type: Posts; User: MontyBMan
It worked fine for me, using the drivers for windows 7 that are linked from the store page for the R.I.C.E. cable. I at first thought the software was to blame but then i switched the TXN and RXN...
I determined the length of my blade using my height. I oringally had a 36" blade but shortened it because I'm only 5'10" to 32". It helps a lot. handle length has a lot to do with it as well i think....
That is what I figured. I've been looking at a specific way of doing it using screw posts as well to make it more secure... I've been trolling the threads here to see how people have done their...
Right, the switches are the little momentary technical switches mounted inside the hilt, so no need to resistor those as they don't have any LEDs. Thanks for the feedback FJK :)
Updated Wiring diagram, should be 100% accurate but please critique if anything ends up sticking out as wrong. I would just edit the first diagram but both have their merits.
...
I can see where you're coming from there. From what I've seen the PC can run reliably using a single cell 3.7v 18650. I'll probably just end up using a 3.7v 18650 or if I can find a way to fit it...
I run into problems with the hilt though... when it comes to storage. I'm essentially upgrading a stunt saber that used to just be an LED, a latching switch, a 4AAA Pack and a resistor.
Do you...
Hey guys, I've been lurking for a while and reading the user manual for the Petit Crouton. I was fortunate to get one of them and before I start soldering everything I was wondering if this looked...
Ok, i have to ask, since i'm working on a similar switch setup for a difficult (read: cramped) build. do you just drop the brass sections in from inside the hilt and then slide the chassis in? Or do...
I'm going to be attempting something similar with two momentary switches and possibly drilling and tapping through a threaded section, that's a few months ahead though. the design I'm working with is...
This is good news... I'm going to try and get something ready for this contest just to get my juices flowing.
also, first post in the forums, hi everybody.