Hi All,
I have a PRIZM 5.5 ( I know, I know, my next build will be a CFX I promise) that has 4 accent pads that run at 3.3V at 18mA each. I have a 10 segment light bar LED that I want to wire to...
Type: Posts; User: hutch009
Hi All,
I have a PRIZM 5.5 ( I know, I know, my next build will be a CFX I promise) that has 4 accent pads that run at 3.3V at 18mA each. I have a 10 segment light bar LED that I want to wire to...
Hey This youtube series goes into detail on how to build a Graflex including explaining all the sizes of setscrews and detailing the mods you need to make to the hilt itself. This series came out...
Is Madcow going to make anymore videos for TCSS?
Sorry to hear about the bad health issues. When you're 100% and you finish the walking stick an K4 sabers be sure to post lots of pics
Sloda Foade,
Did you ever build your saber?
Hutch009
Is it safe to charge Trustfire 18650 batteries one at a time in the charger available in the TCSS or should the batteries only be charged in pairs?
Here's the adapter to use with the charger https://www.thecustomsabershop.com/Tamiya-to-JST-charger-adapter-P701.aspx
The screw size is 10-32 I would try either a 1/4inch long set screw or maybe a 1/8 inch long set screw.
Hello All,
I finally found and tested out some lock washers that work with 12mm and 16mm AV Switches.
For 12mm AV Switches follow this link:
...
Which ones would work?
Has anyone here managed to get a replacement double button PCB ? If anyone has I would love to know from where. I managed to damage the button PCB that came in my K4 Kit.
With all the Proffie excitement I still don't really understand what smooth-swing is and would like to understand more. Any information or links welcome.
Hutch009
Hi K6gad,
Thanks for the reply:p
I am trying to avoid using any type of glue and I don't think it would end well for me if I tried modifying normal washers.:shock:
I managed to find lock washers...
Hello All,
Does anyone know where to get locking washers that will fit the 12mm and 16mm momentary AV switches that TCSS sells? I am trying to find some for a MHS v1 hilt.
Thanks in Advance &...
Cool. Thank you for the reply:D
Can a V1 Blade PCB be used with a 7 pin V2 Hilt PCB?
Not a problem. Good luck moving :p
Are you going to offer a pre-soldered PCB connector and pin set again?
Can you post a pic?
I am looking to find out if anyone has used a TriCree Deep Red-Green-Royal Blue LED? Does it create a good Purple? Does anyone have any photos they are willing to share?
I am fairly sure that the pogo pins used in the Neopixel hilt connector are from Mill Max but I don't know the model type and size. Can anyone provide that information?
Thanks in advance
Thanks for the info and the reply :D
I will have a mix of the following types of batteries for different hilts:
http://www.thecustomsabershop.com/Panasonic-Li-Ion-18650-37V-3400mAh-PCB-Protected-Rechargeable-Battery-P853.aspx...
the only thing I can think of is that you were using pure alcohol instead of rubbing alcohol (70% isopropyl) . But I will defer to the more knowledgeable in this forum.
What did you use for insulation between the PEx and the NBv4?