Search:

Received this reply from ERV, on May 4th of all days LOL:
"Check the big rectangular resistor with R150 on it, it should be < 1 ohm with the board fired up and playing sound (activated) measure the...

Stii having the same issue. After contacting the Einstein of sound cards, Erv Plecter, he asked me to check the value of the SMD resistor right next to the LED output pads. Citing that it should have...

Jay-gon Jinn thank you for taking an interest in my post. I was afraid that due to the age/model of the board i am using that no one would bother replying. I cannot send photos due to the fact that i...

I forgot to mention that i utilized the single cell hack for the petit crouton advertised on Erv's website.

Currently getting .24Vdc on my +LED and -LED pads.

Current Setup:
PC 2.0
CREE TRI-XP-E2, GGW wired in Parallel *see power source
power extender for White FoC
5mm Green accent LED going to...

Soldering luckily is one of my strong points. I'm a helicopter electrician by trade so I've hade years of training and Soldering in less than optimal situations.
Although, that route really wasn't...

So after some thought, and a hint from my wife who is currently in school to become an electrical engineer, I thought up a second way to independently run 2 RGB accent LEDS. I would love comments and...

I think I Understand what you are saying. If I use 3 of the PLI/accent LED pads outlined in red in the picture below, and I tinker with the LED sequencing configuration for the PLI setting I could in...

Greenie, thank you for your response. I am a little confused if you are talking about accent LEDs or main LEDs for the blade. I know that with the newer CF boards you can drive multi di LEDs such as...

First, I would like to admit that I have been lurking on these forums as an observer for years. Throughout those years every question I have had has been answered without me having to actually post....