Search:

If you don't want sound, that makes it a lot easier

I most definitely listed the battery holder in my post. :D

They are 18650 batteries, they are larger than AA batteries. The battery goes into the holder, the holder drops into the mount and the mount is then slid up into the hilt. They hole only 1 18650...

You can use these which you can remove and charge in this and you can use this and this to hold it.

I haven't built anything yet so I may not be 100% correct with this but I will try me best.

You only need one of those batteries if you want to go with that setup. You recharge it by adding a...

I believe that resistor is for the LED inside the switch, not your main LED.

I'm glad the NB is back in stock, now I'm just waiting on the other 4 parts I need to come back into stock. I'm crossing my fingers that it will be soon.

For the time being, I just want to put lights in my saber and use a single rebel led. If later on, I wanted to use a NB for sound, is there a way to wire it to have some sort of an effect on the led?

Hey JakeSoft, how is it coming along?

I found a spray paint by Krylon called Covermaxx. It claims to be a primer with durable adhesion. Do you think it is possible to just use this as a primer, paint, and clear coat since it is glossy?

I am assuming it would fit into an MHS1 build? I am holding out and hoping that a yoda lightsaber is released in the blade builder line.

Ah i see, so the dynaohm resistor will make sure the led in the switch doesn't burn out?

Hey everyone, I am going to purchase all my parts soon for a saber, the only think I am confused about is the wiring of the switch. I have attached a picture of what I think is correct but I could...