So i disconnect my switch and my speaker as i ve read post about the problem could come from these
And yes it did, i dont really from where exactly but i resolder and its working
I think i could be...
Type: Posts; User: wolf69
So i disconnect my switch and my speaker as i ve read post about the problem could come from these
And yes it did, i dont really from where exactly but i resolder and its working
I think i could be...
Did you find the cause, i have the same issue.
I didnt have time to discon'ect my switch and make the contact manually to see if the problem came from the switch or not.
I will try it tonight.
I used a standard plug from a charger not connected to the AC
13423
Here is my wiring.
Don't look at the yellow wire (switch button, the other is missing)
Do you something wrong?
Hi,
I have been building a lightsaber with an econo board and a recharge port, all is working well except for the kill key.
For exemple When i plug a male plug in my recharge port the circuit is...
Thank you
That's what i was thinking but i needed a second opinion
Up please
I know the green is the clash sensor, i assume the big black thing is the swing sensor but i dont understand why there are 3 legs/wires
Hello,
I would like to buy a smart charger for a rechargeable port.
The main problem is that the shipping in all US shop are above the price of the charger, so any of you know a shop to buy these...
Hum ok
So for this li ion battery no need for transistor since the voltage is approximatively the same as the led right?
yes but you divide amperage in parrallel right? so what is the battery requirement for 3A?
Ok i didnt see the difference E2 and E you may be right
But my question is about a tri xp-e(2?) green so 3 x 3.58v
Here:
http://www.cree.com/~/media/Files/Cree/LED-Components-and-Modules/XLamp/Data-and-Binning/XLampXPE.pdf
But either way the voltage is still too high for my battery solution
Forgive my ignorance but how come that a li ion 3,7V is better than 4x AAA 1,5v (6V total)?
After reading more stuff i have be to the conclusion that powering 3 GGG is "impossible":
One green...
Thank you both for you fast reply!
I have wire my tri cree GGG in serie with 4 AAA batteries 6V.
The resistor is 3W 2ohms.
I m not really happy with the brightness and the light if not even...
Hello,
I recently received my empty hilts from US, i wanted to intall the electronics by myself so i asked for dissamble hilts.
My battery holder is like this with the resistor apparently...
Thank you!
But how comes it has 3 wires attached to it?
What pin is (-), (+)?
I m playing with this board but i dont know where is the swing sensor, i want to upgrade it with 2 sensors!
Thx
Hi,
I have dissasemble a bladebuilder Vador, and i want to upgrade to a double swing sensor but i have doubts about where is the original swing sensor 13018
Thank you for your answer!
That what i thought that 2x li ion would be mandatory only for tri cree.
And since on of my futur build would be for my little brother i would stick wit 4xAA.
For...
Hello,
I have been doing a lot of research and i'm still unclear about the power source.
My plan is to use an econoboard, and put a CREE XP-E, new speaker, 2 swing sensor.
1/What will be the...