Hello everyone, here is a little update:
another NBV4 works without any problems with the same wiring in the same saber. On the board where the problem occurred, is now also the AMP defective. I...
Type: Posts; User: Whiskey2015
Hello everyone, here is a little update:
another NBV4 works without any problems with the same wiring in the same saber. On the board where the problem occurred, is now also the AMP defective. I...
The inner tube, that Hold the Electronics, is completely from plastics. No Chance to produce a short, that way.
The Board is slightly! shrinked in, just it can't strip off. And the Contacts are...
Update: if I set "offd" to a value below 10, there seems to be no problem anymore.
Except that sometimes I turn off the Saber at the "Swirl from inverted".
I tested the wiring completely,...
I've tested a few more:
Error occurs when Saber was in Deep Sleep mode. When I reboot the saber by Killswitch a few times, suddenly it works. And if once it has worked, it will continue to work....
I know. But no Matter how long I hold the switch down, the saber won't turn off.
Again this annoying guy from Germany. 🙄
I have just completed my first saber with a NB4. and I'm really excited. except for a little problem. It can only be turned off sometimes. I usually hold...
I packed it in shrink tubing and wrapped it with foam. So I pushed it all the way back into the hilt. Now I can reach the SD card if I unscrew the Pommel.
Ahh, good to know!
NB arrived yesterday, and of course can't wait to wire it.
It works! Swing, Foc, on-off sounds. everything works. I am really excited. Now I have to see how I get it all...
Ahh, thats it!
I use a Cree XP-E, red: 500mA, 2,1V, 625nm
This Question I asked to me before...Better to calculate with average Current (3,7V) or fully load (4,2V)?
Hello @all,
I'm new at the saber-scene and ordered a NB for my DIY saber. Today the Package arrived in Germany, an I wonder how I should fix the Bord inside the Saber.
SD-Card on one side,...
Hi Tom,
Thanks for your Reply, good to know not to be the only old man here.
My calculation for the Resistor follows the Instructions in NB Manual. So it will be interesting, wheres my...
Hello everyone,
I'm new here in the forum. My name is Matthias, I am from Germany and am so old that I have seen the original of "ANH" in the age of ten years in the cinema.
Now, 39 years...