Search:

Update:
The speaker was fine, the battery was fine, it was the NB. When it took it out of there if found scoring and discoloration around the speaker pads. Thanks for all the help everyone.

Here are a couple pictures of the NB and speaker. Let me know if i need better photographs. Can anyone tell if there are problems with either?
910791089109

I replaced the speaker; no change. the problems with the sound started with plugging it in to the wrong charger. before that it was preforming perfectly. i had to order some more parts, when they...

troubleshooting update:
i charged the battery with the correct charger. i never saw the charger's light turn to green, but it was on there for hours. now the saber illuminates and stays on. i...

GFJedi, i have not used the correct charger. i'll have to order one.

I have done no troubleshooting. i was hoping that folks on this forum would help me with that. one issue is, i have no spare...

I recently completed my first saber. i was extremely stoked; it worked beautifully until i went to charge it up. I used a Li-Ion 18560 3.7v 2600mAh cell to power the saber and, without paying proper...

Roger on 1 and 2.
On 3, my momentary has an LED (amber ring AV). Does just hooking it up to the actuation switch pad on the NB allow it to light up? Don't i need to resistor it? Would i need to use...

Master sabersmiths,
I am new to sabers and electronics in general. i got almost everything i need in my first order. Things i forgot include: kill plug, extra wire and heat shrink. Couple novice...

Thank you both,
For the resistors, the led.linear1 wizard recommended a 1/8W (82ohm) resistor for the momentary anti vandal with yellow LED (assuming the 3.7v 18650 battery), but I can't find an...

I would like a saber that has the following sound capabilities: start-up and shut-down, idle hum and clash on contact (two saber blades coming into contact). Any of the other bells and whistles and...