Search:

Type: Posts; User: RMDphoto

Search: Search took 0.00 seconds.

  1. Replies
    14
    Views
    8,659

    Thanks everyone!!! The emitter and pommel...

    Thanks everyone!!!



    The emitter and pommel as with the rest were acid etched. Then I hit the whole saber with a Prismatic Powders Tinted Clear II which gave the etched surface a darker grey...
  2. Replies
    14
    Views
    8,659

    Cliche Sith Saber Name Here

    Yeah, so I don't have a name for it. But here is my very first build. All TCCS MHS parts, featuring a full MHS chassis with an NBv4, recharging, Red-Red-Deep Red tri-cree(set for FOC), and bass...
  3. But if I remove the remove the chassis disk then...

    But if I remove the remove the chassis disk then the chassis will slide around in the hilt. I got exactly what was listed in their video so it would lock into place between the hilt and pommel.
  4. Chassis causing Hilt to Pommel Gap...need help

    Hey all, I put together all my parts that I ordered and I am getting a gap between the Hilt and the Pommel. I ordered the chassis parts based on this video....
  5. Replies
    3
    Views
    3,563

    Thank you much, thats exactly what I am wanting...

    Thank you much, thats exactly what I am wanting to do with the LED's
  6. Replies
    3
    Views
    3,563

    Well, I found a resistance calculator and I added...

    Well, I found a resistance calculator and I added two 1.5Ohm 5w resistors to the wishlist along with a power extender to do flash on clash.

    Would really appreciate someone looking everything over...
  7. Replies
    3
    Views
    3,563

    1st Build Parts list check.

    Hey all, so this will be my first DIY build and am a bit intimidated.

    This is what I am going toward, a custom etched take on a dark side Satele Shan saber. (will end up doing two down the...
Results 1 to 7 of 7