Search:

Type: Posts; User: Crims

Search: Search took 0.00 seconds; generated 37 minute(s) ago.

  1. I resoldered the speaker wires only (and drilled...

    I resoldered the speaker wires only (and drilled a separate hole in the chassis for them so they wouldn't cross the board. Works normally now!

    EDIT - and now back to where I was before after one...
  2. I made sure it's a momentary. I can try...

    I made sure it's a momentary. I can try resoldering if necessary.
  3. Ok, I charged the battery fully which solved the...

    Ok, I charged the battery fully which solved the swing sounds. It still won't turn off though.

    I found one other person having this problem, didn't see a resolution on it. I also checked the...
  4. Not sure on the first - this was a fresh out of...

    Not sure on the first - this was a fresh out of the box battery from TCSS. The second is a yes, I have a resistor on it, I believe 1.8 ohms. I'm using an LED that once went to a US saber.
  5. NVB won't turn off, constantly plays swing sounds if picked up

    So, I wired a NBv2 with no recharge port or FoC, using page 9 of the manual. I hooked everything up and it will change soundfonts while off and start up no problem, but won't power down when I hold...
  6. Replies
    3
    Views
    1,682

    That's a relief, thanks! I really didn't like how...

    That's a relief, thanks! I really didn't like how an additional extension changed the aesthetic.
  7. Replies
    3
    Views
    1,682

    Choke / thin neck and securing the blade

    Hi,

    I'm currently working on an easier build, but thinking about what I'd like to do as a personal saber later on.

    This is the design I worked up in MHS builder:

    12781

    My only concern is...
  8. Replies
    3
    Views
    4,135

    Hey, that was it exactly! Thanks a bunch for your...

    Hey, that was it exactly! Thanks a bunch for your help! Now I just need to wire up the switch and do some cram-fu + greeblies.
  9. Replies
    3
    Views
    4,135

    Just to add, I bypassed the transistor on the...

    Just to add, I bypassed the transistor on the negative and went straight from the board negative to LED negative and the light worked fine as far as blinking on and off, but it did have the issue...
  10. Replies
    3
    Views
    4,135

    US Bladebuilder Econo upgrade almost working

    Hi,

    So this is my first project and I've really been thankful for all the help and wiring diagrams here.

    I got a US stunt saber and have been working on adding one of the Hasbro soundboards to...
  11. Replies
    2
    Views
    15,643

    I'm actually using another LED, hence why the 6v....

    I'm actually using another LED, hence why the 6v. That's just the info I needed though! Using the same calculator you linked. Thanks!
  12. Replies
    2
    Views
    15,643

    Philmore switch forward voltage?

    Hi,

    I'm modding a saber and adding an Obi Wan Bladebuilders soundboard. I picked up a Philmore momentary switch for it and I'm trying to figure out the forward voltage and current to plug into the...
Results 1 to 12 of 12