Hey guys. As I was trying to find a solution to my problem I found this thread. So I hope it's ok if I ask my question on the same post as it's along the same lines.
I wired my red accent light...
Type: Posts; User: KongoBongo
Hey guys. As I was trying to find a solution to my problem I found this thread. So I hope it's ok if I ask my question on the same post as it's along the same lines.
I wired my red accent light...
Hey guys,
Hoping someone could answer this. The Prizm Manual on page 40 for the Trident Wiring (Single Color+FoC) shows The Main Blade of 2 red dice with only 1 of the positive being...
OK! It was a wiring issue. Or, more like a soldering issue. I could not see it but the multi meter was not fooled. It was at the LEDS. The positive on White (FoC) was bridged with the Neg on the...
It's a carbon film from the shop. And yes I'll try and put some pictures up when I get home.
Thanks guys.
Yes I was shooting for a purple. And ya it would burn if I left it on.
Yes, I thought I saw a diagram of it on the PEX. I could not get that to look right so I just put it between the PEX and the NB. I'll re-work that now and see what happens.
Thanks.
Hello folks.
Seeking some help trouble shooting my first build.
I jumped the pad on the PEX with solder and a bit off the trim wire of a resistor. I then have a 0.5 ohm 3w resistor on the...
I wired up my similar build last night. I pulled the kill key and got the boot up sound. When I switched on, I get non stop saber movement sounds, no flash on clash and the .5 ohm 3 w resistor on the...
So I should wire my NBv2 like a NBv3?
Hah! Thanks. I think I'm looking at to many diagrams/videos. Noob Info overload.
Thanks for clearing that up.
Thanks for the info.
I was just a bit confused as sillisquid's diagram has the accent going to a pad near the bottom of the card. And On the NB v2 manual page 12 it shows the pad up near the...
I know this is an older thread, however It's pretty much the same build I'm working on. How did you know where to run the wires for the AV switch? I see in the manual where to wire an accent light....
Greetings,
This is my first post here. I thought it fitting as I've been checking just about every hour for the past month to complete my first build. I think It can also be frustrating to see all...