Search:

Type: Posts; User: Cjh1985

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,983

    I've commonly had that happen with a low battery...

    I've commonly had that happen with a low battery too. Almost always with the spring holders, combination of taping the battery in and -smothering- the smaller terminals in solder fixed it there.
  2. Replies
    13
    Views
    6,376

    Wiring diagram looks good here but I'm admittedly...

    Wiring diagram looks good here but I'm admittedly not a master. I've had this happen and needed to charge the battery up to full before it stopped. If a full charge isn't your problem here, perhaps...
  3. Replies
    13
    Views
    6,183

    Remember that when programming FOC the LEDs are...

    Remember that when programming FOC the LEDs are reversed, so the configuration there would be one blue light on that simply stays on without adding other LEDs on impact. If you want maximum...
  4. Replies
    2
    Views
    2,293

    There's a lot of room for creativity with the...

    There's a lot of room for creativity with the retention screw on round emitters like this. Ideally on any emitter you'll want it somewhere that focuses pressure at a point where the blade has the...
  5. Replies
    4
    Views
    2,132

    The rods support the chassis, so it looks like...

    The rods support the chassis, so it looks like what you have right now should work. It seems unlikely the chassis could do more than slightly vibrate with the rods both being held by set screws. Or...
Results 1 to 5 of 6