Search:

thank you. never thought of that.... well i kinda did but didnt think it was possible to pass a wire that way, thought the speaker would be too tight of a fit.... i think it may work out... thanks......

So i am planning to build a saber and i have come to a situation.
i am going to build a chassis, but i have to make it a 2 part chassis. i know there is technically an easy fix, but if i can avoid...

Ha now i feel a little silly, but yes, those pins match up with the colors.
i will try to add a written explanation of what my wiring is.

3.7v lion + connect to 3.7v Lion + (red)
3.7v Lion -...

Thanks all for the help,



my legend in the bottom corner is the pin set up from the obsidian, i used color coating [part of my legend] to correspond with the pins. sorry for the size, it is...

Hello all,

i am planning on building my first saber, i want to make sure i have my wiring right,

I will be using a 7.2V Double Lio-on power source

illuminated latching switch @ 3.3v 20mA...

Hello all,

I read somewhere that to constant current driver from tcss needs a resistor. So my Main question is if I have a resistor for my ccd do I need a additional resistor for my LED.
...

Sweet, thanks guys. that means i idea, should be spot on...i will have to post when i start building it.

Hey all

I was wanting to put a 1.25" sink inside the MHS main body to act as a battery can and a sensor/resistor can. Ideas and feed back? Will this work? I figure it should since the ID of the...

Hello all,

i am working on the designs of my first saber build. I want to make sure i have everything Proper before i have to buy the supplies. All the components, minus the 4 mini LED's are from...

Hello all,

i am working on the designs of my first saber build. I want to make sure i have everything Proper before i have to buy the supplies. All the components, minus the 4 mini LED's are from...

Hello all,

Just wondering if anyone could give me some good pointers or tip for building a chasiz or can for a main switch at pommel end to hold all of my internal components?

the total length of my MHS pasts is 13 inches, the pommel would take up the main switch, the handle is 7", the milled piece which is 1.5 inches is where i want the crystal chamber, a 1.2 inch...

http://s1141.photobucket.com/albums/n600/jedi-hayze/?action=view&current=IMG_0095.jpg

http://s1141.photobucket.com/albums/n600/jedi-hayze/?action=view&current=IMG_0094.jpg

sorry it took some time to get this stuff loaded, i appreciate you all trying to help... i hope these new...

sorry peeps, i thought i had deleted that thread haha....guess not oops....

http://s1141.photobucket.com/albums/n600/jedi-hayze/?action=view&current=Screenshot2011-05-04at101610PM.png
...

IF anyone could help me on ideas for layouts for my saber that i am planing to build.

I want to have a luminated power switch at the pommel end of my saber. using two lithion batteries with a...